Technical Support    (855) 512-4817    EMAIL US

Our Blog

Brocade ICX 6450 Configuration Tips

Sometimes while working on new flavors of network gear, you learn a few things that should be posted for other engineering folks, to help make life just a bit easier.  TBNG Consulting provides clients with several options for Layer 2/3 network switching gear.  Lately, our project engineering teams have been implementing several Brocade Ethernet switch upgrades.  To this end, I’m providing two useful tips for my readers. You can thank me later.

Resetting Brocade ICX series password:

This has happened to all of us at one point or another—you copy over a switch configuration with AAA Local authentication enable, but one forgets to configure the proper privilege (e.g. level 0 for read/write) for the admin username – and suddenly,  BAM! Locked out.

To reset the password do the following:

1)    Reboot switch via console session; pay careful attention to loading prompts

2)    Type the letter B prior to loading of flash to enter Boot Monitor mode.

3)    At prompt, simply type: no password

4)    Reboot switch by typing: boot

Brocade ICX 6450 10-G SFP Modules:

This is very useful for those pre/post sales engineers, particularly as many companies migrate to faster 10 Gbps speeds.  By default, Brocade ICX switch ports 1 and 3 are 10 Gbps stacking ports. Additionally, without a license at bootup, ports 2 and 4 come up in 10 Gbps port speed in an error disabled state. To enable ports 2 and 4 to 10 Gbps port speed, purchase the Brocade ICX6450-2X10G-LIC-POD license.

TBNG Consulting can help with Brocade switching solutions for your organization.  Contact us today, at or at 855-512-4817, for additional information.
TBNG Blogger

Written by TBNG Blogger


    Subscribe to Email Updates


    see all